Page 1 of 1

Hop up buckings Vs FPS

PostPosted: Wed Jan 05, 2011 6:56 am
by IconarmsDealer
I see that there are several grades of rubber used for hop Up buckings. Is there a base line recomendation for using hard , med, soft with certain FPS set ups? to be clear, What Im asking is if the gun fires at XXXX Fps should we use hard ,soft, med per given Velocity?
Note Im not asking about BRANDS just density

Re: Hop up buckings Vs FPS

PostPosted: Wed Jan 05, 2011 3:19 pm
by AlexDean
i am not sure but i think the density just portrays how much abuse it can take. lighter density plastic wears off easier than harder yes?

Re: Hop up buckings Vs FPS

PostPosted: Wed Jan 05, 2011 4:03 pm
by mahabra695
If your shooting 375fps or over, I would use a hard bucking. Anything less a soft or medium bucking.

Re: Hop up buckings Vs FPS

PostPosted: Wed Jan 05, 2011 4:06 pm
by ryukensfj
In general I would use these guidelines... Hard = 430+fps, Soft = < 400 fps, and Med = in between but I would usually just choose between soft and hard. Soft has the best accuracy but doesn't last as long as hard. But with high fps guns the soft bucking will be ripped. Personally I think soft buckings are the best for AEGs that are within TAC rules.

Re: Hop up buckings Vs FPS

PostPosted: Thu Jan 06, 2011 12:09 am
by AxisOfOil
I use a g&g green bucking for everything. Works very well for low and high fps, and everywhere in between.

It's softer than a lot of the "soft" buckings I've seen, but tougher than all but the hardest.

Re: Hop up buckings Vs FPS

PostPosted: Thu Jan 06, 2011 4:32 pm
by SinfulPain
ryukensfj wrote:In general I would use these guidelines... Hard = 430+fps, Soft = < 400 fps, and Med = in between but I would usually just choose between soft and hard. Soft has the best accuracy but doesn't last as long as hard. But with high fps guns the soft bucking will be ripped. Personally I think soft buckings are the best for AEGs that are within TAC rules.


There's one exception I've found to that, and it's the Prometheus buckings. Everywhere I've read has said 500fps and lower for the soft, and above 500, to use the hard. *THIS APPLIES TO ONLY THE PROMETHEUS BUCKINGS*

I have a G&G green in my M4, and its accuracy went up a lot over the stock one. If you're shooting anything under 430 fps, use the G&G green.

~Brian

Re: Hop up buckings Vs FPS

PostPosted: Thu Jan 06, 2011 5:52 pm
by AxisOfOil
SinfulPain wrote:
I have a G&G green in my M4, and its accuracy went up a lot over the stock one. If you're shooting anything under 430 fps, use the G&G green.

~Brian


I use them for ~600 fps guns as well. Last a little 15k-20k rounds at that power level.