you will need--
______________
1. MAAS metal polish/ restorer
2. washcloth
3.another washcloth
4. tissue
5. cleaning rod
1. remove hopup assembly and bucking.
2. squeeze a medsium sized dab of MAAS paste onto washcloth, and begin rubbing all the way around the barrel with the cloth.
3. after the barrel is warm, and has a chrome/ brass sheen/tone stop rubbing.
4. remove excess dirt and grime with the second cloth. you will see there is grime at both ends of the barrel near the hopup placement area. wipe off the light grime.
5. some of the loose grime will still be inside the barrel... place small ball of tissue into one end of the barrel, and use it to push the grime out.
6. place barrel near a sink head, and let hot water run through the barrel for about 40 seconds. repeat tussue/ clening rod process until the interior of the barrel is clean and dry.
7. spray light amounts of silicon oil around the hopup cuttings on the end of the barrel.
8. lube bucking, and hopup assembly, return to barrel.
9. CONGRADULATIONS YOUVE SUCCESSFULLY CLEANED YOURE BARREL
