Page 1 of 1
M249 Wire Set
Posted:
Sat May 30, 2009 6:02 pm
by AZsharpshooter
Does any one know were I would be able to get an M249 wire set that goes to the stock. I haven't been able to locate one as of thus far, so any held would be appreciatied.
Re: M249 Wire Set
Posted:
Sat May 30, 2009 6:29 pm
by quadro
You can just buy some low resistance wire and wire it to the back yourself.
Re: M249 Wire Set
Posted:
Sat May 30, 2009 8:57 pm
by KileyHAZ
quadro wrote:You can just buy some low resistance wire and wire it to the back yourself.
+1, I have the mk2 gb if you wanna know the lead lengths...
Re: M249 Wire Set
Posted:
Sun May 31, 2009 9:34 am
by Boles
I had the para stock and just did the wiring myself. I took some wire from radio shack and took the gearbox out. I also wired it to be able to hold two batteries. So now in my stock I have 2 10.8v batteries. It was pretty easy all you really need is some head shrink wire and a solder gun.
Re: M249 Wire Set
Posted:
Sun May 31, 2009 11:36 am
by AZsharpshooter
Ok I haven't done any wiring myself but hey there's a always first time for everytime. A few quick questions, do I need a fuse? How do I wire the trigger switch? Well Im asking questions does the M249 GB use a Ver 2 Cylinder head, and how do you undo the wires from the Trigger switch. Thanks so much for the help guys.
Re: M249 Wire Set
Posted:
Sun May 31, 2009 4:28 pm
by Savage
I've never wired any guns, but you're probably going to need a soldering iron to get started. Melt the places where the wires connect to the boxes, remove and re-melt, then re place the wires.