Measure the inner barrel more accurately. You might be able to use a 455mm inner barrel. If you are going to get a silencer might as well bring the inner barrel all the way to the end.
http://www.airsoftpost.com/product_info ... s_id=32183
Moderator: Moderators
Crono0001 wrote:accurately measuring it means i have to take it apart
But most websites agree it's about 270.
with a 190 silencer, it would be very very snug with that 460 barrel
AxisOfOil wrote:Crono0001 wrote:accurately measuring it means i have to take it apart
But most websites agree it's about 270.
with a 190 silencer, it would be very very snug with that 460 barrel
Not to mention it will hurt your accuracy once you pass 410mm or so unless you also switch out your cylinder.
460 is about 2 fingerwidths short of full M16 length.
ryukensfj wrote:You need to match the barrel to the cylinder volume. You won't have enough pressure for the new length of barrel, so it will lose speed. The piston will be traveling backwords before the bb exits the barrel causing a slight suction, that will slow down the bb and create some turbulence causing accuracy to fall down.
ryukensfj wrote:Yeah maybe I'm wrong about that...
AxisOfOil wrote:ryukensfj wrote:Yeah maybe I'm wrong about that...
It ends up having the same end effect... but not for that reason.
Users browsing this forum: No registered users and 2 guests