Moderator: Moderators
airsoftguy wrote:From what I know ''Matrix'' motors are Crap and even though that evike says they are the best but most of their parts are in fact made in china. For example I had a Matrix Turbo motor it says that it can pull a M120 but It wont even pull a M110
For example I had a Matrix Turbo motor it says that it can pull a M120 but It wont even pull a M110
xblackthund3rx wrote:theres nothing wrong with the motor it works fine the gun worked completely fine with the original wireset the only reason I had to replace it was because it was my friend gun and before I bought it from him he tried to wire it to the rear and messed up the wire set once I replaced the wire set the gun once again worked as normal and then a couple days after the incident happened
xblackthund3rx wrote:Hey Brian thanks for the info what is the average life of a fuse tho because I had the fuse set up in my G&G for a few months or so before it got put in the Matrix were its life ended lol so it was good at one point
IconarmsDealer wrote:We are just figureheads.
IconarmsDealer wrote:Fuck you you fat mother fucker
Exarach wrote:Could be a junk battery, My P90 used to do this. It would run fine, then blow the fuse, or blow the fuse on startup, or after a few hundred shots. Never could figure it out. Tried fuses, checking the wires, ect. Then one day, my fuse blew out, and that battery melted, turned out the reason for the problem was that I was using the shitty "Hero" battery that came with it. Bought an attack pack..... no problems with it in two years.
Return to Maintenance and Troubleshooting
Users browsing this forum: No registered users and 2 guests